Overflow water uvc led sterilizer

product details: 

uv water sterilizer

1.DC 12V~24V (sterilization module power 6~8W) It’s recommended that
the power supply 2-3 times higher than module.
2.The line sequence of the power interface is: red anode and black
cathode (the red wire is connected to the positive electrode, and the
black wire is connected to the negative electrode. Forbidden to
reverse )
3.Water flow sw itch interface: the water flow switch accessories must
be connected to work normally. Or short-circuit this port as well
works normally.
4.The sterilizer can be powered on only after the sterilizer interface
marked on the icon is connected.
5.The module cannot be dry-burned and it can be energized for a long
time after the water circulated normally.
6.It’s strictly forbidden test for a long time when there is no water flow
with power. The electrical test time should not exceed 30 seconds.

Why choose this uv water sterilizer?

uvc led

Power supply mode: low voltage start; no ballast required

Volume: small size; light weight; easy installation

Features: rapid sterilization; long-term antibacterial

Stability: frequent startup has no effect on lifespan

Environmentally friendly: no mercury; no heavy metals

Response speed: microsecond response; power-on

instant start; output stable

Detailed project picture:

Customer Feedback:

In our RO watre filter systems and these work very well.

We did not test sterilization capacity against Cryptomycota species and Candida auris or Aspergillus species, but all other

microbes seem to be inactivated so the do not grow any more.

As we think it is better to install them on the inlet and outlet of water filter systems, so that filters can be used longer

without contamination, but if contaminated on the filter material, the outlet drinking watre still is 100 % safe.